The LED will continue to slowly flash green and red for 25 After a few more seconds, the LED will slowly alternate betweenįlashing red and green-disconnect the yellow wireħ. The lock will then sound more slow beeps, 1 beep for everyĦ. These 3 beeps are not heard, then restart at step 2).ĥ. The lock will immediately sound 3 short beeps (if With shunt connector connected, re-connect the battery Plug in the (provided) male shunt connector into the yellowĤ. Take out the battery pack and remove battery power by disconnectingģ. At the back of the lock, remove the screw at the bottom ofĢ. (The "out of box" factory default will be restored)ġ. The instructions below are copied from the programming instructions (page 11):
#Indesit wil103 flashing lights manual manual
Long Flash Red (2 seconds on / 2 seconds off) - Board error, replace electronics kit, RP53230 See manual bypass of electronics section of Installation instructions.The solenoid valve is closed and faucet will not operate until batteries are replaced. Extremely Low Batteries - The RED LED is ON, and water will not flow. Solid Red - Lockdown Mode - Replace Batteries.The manual valve must be used until the batteries are replaced. The first time the faucet is used, the Red LED will turn ON, the solenoid valve will be opened and remain open. Rapid Flash Red - Alert Mode - Battery Failure Imminent.The faucet operates normally, solenoid valve is open.
When the water is off, the Red LED flashes once every 5 seconds. While the water is running Solid Red LED is illuminated. Solid Red - Warning mode - Replace batteries as soon as possible.Flashing Blue - Normal operation, the hands-free mode is activated.Solid Blue - Normal operation, "Touch" mode is activated.
0 kommentar(er)
